This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
beyond:osc_commands [2020/01/21 10:41] Bob Varkevisser |
beyond:osc_commands [2020/01/21 11:00] Bob Varkevisser [OSC in Object tree] |
||
---|---|---|---|
Line 6: | Line 6: | ||
===== OSC Message ===== | ===== OSC Message ===== | ||
- | |||
OSC Message contains 3 parts: | OSC Message contains 3 parts: | ||
Line 18: | Line 17: | ||
===== OSC in Object tree ===== | ===== OSC in Object tree ===== | ||
- | The easiest way to find OSC addresses is opening | + | To find OSC commands/addresses |
+ | Open up the tools menu and click object tree to make it visible. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Once the Object | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Once you clicked on an address or command | ||
+ | |||
+ | The OSC address bar with command is highlighted in the example below. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | This OSC address can be used in many locations. | ||
+ | |||
+ | - Internally in the Pangoscript editor | ||
+ | - In BEYOND Universe | ||
+ | - At the midi controller configuration panels | ||
+ | - In third-party OSC applications like Lemur, TouchOSC etc. | ||
+ | |||
+ | Note that not all third-party OSC applications will process OSC as they should. | ||
+ | A known issue is that TouchOSC is not able to process OSC commands to use the | ||
+ | cue grid to its full potential. | ||
+ | |||
+ | |||