This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
hardware:fb4:manual [2020/04/06 17:10] Bob Varkevisser [FB4 ILDA Daughterboard] |
hardware:fb4:manual [2020/04/06 17:12] Bob Varkevisser [FB4 SE Manual] |
||
---|---|---|---|
Line 3: | Line 3: | ||
{{: | {{: | ||
- | <WRAP center round tip> | ||
In this manual, menu option of the FB4 are enclosed in square brackets (**[ ]**) (e.g. Set **[Operation Mode]** to **[BEYOND/ | In this manual, menu option of the FB4 are enclosed in square brackets (**[ ]**) (e.g. Set **[Operation Mode]** to **[BEYOND/ | ||
- | </ | ||
Line 438: | Line 436: | ||
FB4 allows you to connect an optional Ether-con connection port. | FB4 allows you to connect an optional Ether-con connection port. | ||
- | <WRAP center round tip> | ||
Note that you can only use one ethernet port at the same time. I the Ethercon port is connected; the onboard port cannot be used. If the Onboard ethernet port is in use, the Ether-con cannot be used. | Note that you can only use one ethernet port at the same time. I the Ethercon port is connected; the onboard port cannot be used. If the Onboard ethernet port is in use, the Ether-con cannot be used. | ||
- | </ | + | |
{{: | {{: |