This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
hardware:fb4:manual [2020/06/11 19:20] 127.0.0.1 external edit |
hardware:fb4:manual [2023/08/07 11:53] Bob Varkevisser [Power Input] |
||
---|---|---|---|
Line 383: | Line 383: | ||
==== Power Input ==== | ==== Power Input ==== | ||
The power requirement is a single +5 to +30 volts DC, at 2 watt. This may be sourced from the same power supply that feeds the scanners or laser diode drivers. | The power requirement is a single +5 to +30 volts DC, at 2 watt. This may be sourced from the same power supply that feeds the scanners or laser diode drivers. | ||
+ | |||
+ | **Note: On new FB4, the power connector has been replaced by an 2-pin JST PH cable connector.** | ||
{{: | {{: | ||
Line 517: | Line 519: | ||
|The output of the lasers is flickering in [**DMX-512**]/ | |The output of the lasers is flickering in [**DMX-512**]/ | ||
- | ===== FB4 Downloads ===== | ||
- | * {{ : | ||
- | * {{ : | ||
- | * {{ : | ||
- | * {{ : | ||
- | * {{ : | ||
- | * [[https:// | ||
- | * [[https:// | ||
- | * [[https:// | ||
- | * [[https:// | ||
- | * [[https:// |