This shows you the differences between two versions of the page.
hardware:fb4:osc_commands [2020/02/25 18:19] Bob Varkevisser created |
hardware:fb4:osc_commands [2020/06/11 19:20] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== FB4 and OSC ====== | ||
- | |||
- | |||
- | FB4 can be controlled through OSC. If you use the right syntax, you will be able to control all FB4's in your network. | ||
- | |||
- | ===== FB4 Address prefix ===== | ||
- | |||
- | The FB4 OSC address is based on the serial-number. The OSC address is buildup as follow: | ||
- | |||
- | / | ||
- | /*serial number*/ | ||
- | |||
- | The address always contains 5 numbers. | ||
- | |||
- | If the FB4 serial number is 1234 the actual FB4 OSC address will be | ||
- | |||
- | The following examples shows how you can set the parameter mode on FB4 with serial 2356. | ||
- | |||
- | / | ||
- | |||
- | / | ||
- | | ||
- | | ||
- | | ||