Differences

This shows you the differences between two versions of the page.

--- quickshow:projection_zones [2019/10/07 16:22]
Igor Strakhov
+++ quickshow:projection_zones [2023/03/21 20:24]
Lyra Letournea [Geometric Correction section]
@@ Line 8: / Line 8: @@
 The **Projection Zones** window is shown below.
-{{:quickshow:pz1_4_0.png|}}
+{{:quickshow:qs_projection_zones_full_window_general.jpg|}}
 There are 30 projection zones which can be selected on the left side of the window. When you click on a zone in the left side, the tabs on the right allow you to view and adjust the parameters for each projection zone. To view and adjust the parameters, click on the **Geometric Correction, Preview, Beam Attenuation Map** or **Advanced** tab.
@@ Line 34: / Line 34: @@
 To adjust the geometric correction, you click, on the different **Correction Types** and then move the sliders that appear on the sides and top of the window, or you can click and drag the mouse in the window area.
-{{:quickshow:pz2_4_0.png|}}
+{{:quickshow:qs_projection_zones_full_window_geometric_correction.jpg|}}
+**Auto Mesh**
+As of QS 5.2 you can use the "Auto Mesh" tool which allows you to mesh your zone into place instead of using geometric correction, this will help users out a lot with off axis graphic projection.
+{{:quickshow:qs_projection_zones_full_window_automesh.jpg|}}
 ===== Preview Window Appearance section =====

Complete Help Docs