This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
tools:lcflash:object_point_spacing [2021/04/23 13:30] Bob Varkevisser [Use default settings] |
tools:lcflash:object_point_spacing [2021/04/23 13:30] Bob Varkevisser [AutoSpace Curve detect] |
||
---|---|---|---|
Line 52: | Line 52: | ||
**AutoSpace Curve detect** controls the sensitivity to curves. The minimum setting of 0 means no curves are detected -- the visible density for straight lines is always used. The maximum setting of 100, means Lasershow Converter FLASH will place a high density on lines even if they are only slightly curved. | **AutoSpace Curve detect** controls the sensitivity to curves. The minimum setting of 0 means no curves are detected -- the visible density for straight lines is always used. The maximum setting of 100, means Lasershow Converter FLASH will place a high density on lines even if they are only slightly curved. | ||
- | Note that with all of this flexibility, | + | Note that with all of this flexibility, |
===== Beam path for this object ===== | ===== Beam path for this object ===== |