Differences

This shows you the differences between two versions of the page.

--- hardware:fb4:osc_commands [2020/02/25 18:48] – [FB4 Address prefix] Bob Varkevisser
+++ hardware:fb4:osc_commands [2025/08/20 21:06] (current) – [FB4 and OSC] Bob Varkevisser
@@ Line 2: / Line 2: @@
-FB4 can be controlled through OSC. If you use the right syntax, you will be able to control all FB4's in your network.
+FB4 can be controlled through OSC. If you use the correct syntax, you will be able to control all FB4s in your network. FB4 listens for OSC commands on port 8000.
 ===== FB4 Address prefix =====
@@ Line 13: / Line 13: @@
   /*serial number*/*command* *value*
-The address must contain contains 5 digits. So 1234 becomes 01234.
+The address must contain contains 5 digits. So if the FB4 serial is 1234, the address becomes 01234.
-If the FB4 serial number is 1234 the actual FB4 OSC address will be:
 The following examples shows how you can set the parameter mode on FB4 with serial 2356.
-  /FB4-01234/operation_mode 1
+  /FB4-02356/operation_mode 1
-  /01234/operation_mode 2
+  /02356/operation_mode 2
 ===== FB4 OSC Command List =====
 ^ OSC Tag ^ Minimum ^ Maximum ^ Symbol values ^
-|operation_mode|1|8| |
+|operation_mode|1|9| 1 = BEYOND & QuickShow, 2 = ILDA, 3 = DMX, 4 = ARTNET, 5 = Autoplay, 6 = Timecode, 7 = Slave mode, 8 = Test mode, 9 = sACN |
 |Master Brightness|0|100| |
 |master_size|20|100| |