Differences

This shows you the differences between two versions of the page.

--- tools:lcblender:start [2026/01/16 08:42] – [instruction is for Blender LTS version 3.3 till 4.0] Bob Varkevisser
+++ tools:lcblender:start [2026/10/27 13:28] (current) – Bob Varkevisser
@@ Line 16: / Line 16: @@
   - Install a Long Term Support (LTS) version Blender, which can be found here:: (https://www.blender.org/download/lts/)
-  - Run the Lasershow Converter Blender installer (LCBlender_install.exe), which can be found in the **InstallSupport** folder where BEYOND is located. Or located on the wiki at the [[:download_center|Download Center]].
+  - Run the Lasershow Converter Blender installer (LCBlender_install.exe), which can be found in the **InstallSupport** folder where BEYOND is located. Or located on the wiki at the [[https://pangolin.com/en-nl/pages/downloads?q=blender+3.3&brand=Pangolin+Laser+Systems|Download Center]].
   - Start Pangolin BEYOND first, and then start Blender.
   - In the main Blender window, select **Edit** on the main menu, and go to **Preferences**{{:tools:lcblender:blender1.png?400|}}
@@ Line 27: / Line 27: @@
   - Install a Long Term Support (LTS) version Blender, which can be found here:: (https://www.blender.org/download/lts/)
   - - Start Blender.
-  - Run the Lasershow Converter Blender installer (LCBlender_install.exe), which can be found in the **InstallSupport** folder where BEYOND is located. Or located on the wiki at the [[:download_center|Download Center]].
+  - Run the Lasershow Converter Blender installer (LCBlender_install.exe), which can be found in the **InstallSupport** folder where BEYOND is located. Or located on the wiki at the [[https://pangolin.com/en-nl/pages/downloads?q=blender+4.5&brand=Pangolin+Laser+SystemsDownload Center]].
   - In the main Blender window, select **Edit** on the main menu, and go to **Preferences**{{:tools:lcblender:blender1.png?400|}}
@@ Line 269: / Line 269: @@
 **Setting the size of the output image and animation range** Output Properties Blender Panel, we recommend the window size be set to 320-by-320 as shown below. This allows for fast rendering into the **Blender Render** window, and also allows this window to not take up too much space.
+Note: Lasershow Converter Blender does corner detection calculations and curve detection calculations based on the Output Size settings. The default values for the curve and corner settings are based on a frame window output size of 320-by-320 or 320-by-240. If you choose a different output size (such as 640-by-480), this may require you to change Lasershow Converter Blender's corner and curve settings.
 {{:tools:lcblender:blender20.png?400|}}