====== Enable Laser Output button ======

The Enable Laser Output button is found at the far right of the toolbar, just above the Laser Preview window.

{{:quickshow:tb_enablelaser.jpg|}}

===== Enabling laser output =====

In order to enable output from the FB3 laser controller, the Enable Laser Output button must be pressed.

===== Laser output is always disabled by default =====

Since there is a possibility that an untrained operator might activate the laser during a time that is not appropriate (for example, when workers are in a room preparing for an event), laser output is always disabled by default, and it is always required for the laser operator to consciously activate laser output.

**All editors and setup windows also have their own Enable Laser Output (Show it now) button**

The **Enable Laser Output** button on the QuickShow toolbar is not the only Enable Laser Output button. In fact, each editor window, and setup window within QuickShow also has a button named **Show it now** which will enable the output from that specific window. Again, the laser operator must consciously enable laser output in order to get any output from QuickShow.


----

See Also

  * [[quickshow:blackout_and_pause|Blackout and Pause buttons]]
  * [[quickshow:main_control_window|Main Control Window]]

[[quickshow:|Return to Index]]