This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
beyond:package-sender [2020/02/26 12:16] Bob Varkevisser |
beyond:package-sender [2020/06/11 19:20] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Send packages to BEYOND ====== | ====== Send packages to BEYOND ====== | ||
- | BEYOND accepts incoming TCP and/ | + | BEYOND accepts incoming TCP and/ |
The advantage of this is that that this allows you to control BEYOND over ethernet. | The advantage of this is that that this allows you to control BEYOND over ethernet. | ||
- | This configuration uses the free utility [[https:// | + | The example |
===== Enabling Talk server and client ===== | ===== Enabling Talk server and client ===== | ||
- | Open | + | Open **Settings |
- | + | ||
- | **settings | + | |
{{: | {{: | ||
- | Now you need to enable the Talk server service and talk server client service in the network settings window. Open up | + | Now you need to enable the Talk server service and talk server client service in the network settings window. Open up **Settings >> network >> Network settings**. |
- | + | ||
- | **Settings >> network >> Network settings**. | + | |
The default ports used are 16062 for UDP and 16063 for TCP. | The default ports used are 16062 for UDP and 16063 for TCP. | ||
Line 32: | Line 28: | ||
If BEYOND is running on the same machine, the IP address will be 127.0.0.1 . | If BEYOND is running on the same machine, the IP address will be 127.0.0.1 . | ||
- | In this case I am sending the command " | + | In this case I am sending the command " |
+ | |||
+ | **//Note that every command needs to be followed by \r\n (CR LF aka line separator) as shown below.//** | ||
- | {{: | ||
+ | {{: | ||