User Tools
hardware:fb4:manual
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
hardware:fb4:manual [2020/04/06 17:14] Bob Varkevisser [Onboard DMX out] |
hardware:fb4:manual [2023/08/07 11:50] Bob Varkevisser [Power Input] |
||
|---|---|---|---|
| Line 383: | Line 383: | ||
| ==== Power Input ==== | ==== Power Input ==== | ||
| The power requirement is a single +5 to +30 volts DC, at 2 watt. This may be sourced from the same power supply that feeds the scanners or laser diode drivers. | The power requirement is a single +5 to +30 volts DC, at 2 watt. This may be sourced from the same power supply that feeds the scanners or laser diode drivers. | ||
| + | |||
| + | **Note: On new FB4, the power connector has been replaced by an 2-pin JST PH cable.** | ||
| {{: | {{: | ||
| Line 517: | Line 519: | ||
| |The output of the lasers is flickering in [**DMX-512**]/ | |The output of the lasers is flickering in [**DMX-512**]/ | ||
| - | ===== FB4 Downloads ===== | ||
| - | * {{ : | ||
| - | * {{ : | ||
| - | * {{ : | ||
| - | * {{ : | ||
| - | * {{ : | ||
| - | * [[https:// | ||
| - | * [[https:// | ||
| - | * [[https:// | ||
| - | * [[https:// | ||
| - | * [[https:// | ||
hardware/fb4/manual.txt · Last modified: 2023/08/07 11:53 by Bob Varkevisser
