This shows you the differences between two versions of the page.
quickshow:bypass_specs_warning [2020/03/02 23:42] Bob Varkevisser [Bypass PC specifications warning] |
quickshow:bypass_specs_warning [2020/06/11 19:20] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Bypass PC specifications warning ====== | ||
- | |||
- | If you receive a PC specs warning when starting the software, it means that your PC does not meet the minimal system requirements required to run the version of QuickShow that you are using. | ||
- | |||
- | |||
- | **This also means that we cannot guarantee stable output on your laser equipment. We highly advice to use hardware that meet the [[quickshow: | ||
- | |||
- | |||
- | ==== Bypass the specifications warning ==== | ||
- | |||
- | You can disable this warning by adding a piece of text to the QS.ini file. | ||
- | |||
- | - Locate the QS.INI text file that you will find inside the main directory of your QuickShow installation. (Most often, this file is located in the directory C: | ||
- | - Right click on QS.ini and open up the file with notepad. | ||
- | - Copy the text from the block below and paste this at the bottom of the QS.INI file. | ||
- | |||
- | Once the text is added, QuickShow will not check your PC specifications and will open. | ||
- | | ||
- | [PC] | ||
- | AlwaysCheckPC=0 | ||