User Tools
quickshow:bypass_specs_warning
Differences
This shows you the differences between two versions of the page.
|
quickshow:bypass_specs_warning [2020/03/03 16:39] Bob Varkevisser |
quickshow:bypass_specs_warning [2020/06/11 19:20] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Bypass QuickShow PC specifications warning ====== | ||
| - | |||
| - | If you receive a PC specs warning when starting the software, it means that your PC does not meet the minimal system requirements required to run the version of QuickShow that you are using. | ||
| - | |||
| - | |||
| - | **This also means that we cannot guarantee stable output on your laser equipment. We highly advice to use hardware that meet the [[quickshow: | ||
| - | |||
| - | |||
| - | ==== Bypass the specifications warning ==== | ||
| - | |||
| - | You can disable this warning by adding a piece of text to the QS.ini file. | ||
| - | |||
| - | - Locate the QS.INI text file that you will find inside the main directory of your QuickShow installation. (Most often, this file is located in the directory C: | ||
| - | - Right click on QS.ini and open up the file with notepad. | ||
| - | - Copy the text from the block below and paste this at the bottom of the QS.INI file. | ||
| - | |||
| - | Once the text is added, QuickShow will not check your PC specifications and will open. | ||
| - | | ||
| - | [PC] | ||
| - | AlwaysCheckPC=0 | ||
quickshow/bypass_specs_warning.txt · Last modified: 2020/06/11 19:20 (external edit)
