User Tools
quickshow:bypass_specs_warning
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
quickshow:bypass_specs_warning [2020/03/02 23:36] Bob Varkevisser [Bypass the specifications warning] |
quickshow:bypass_specs_warning [2020/06/11 19:20] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Bypass PC specifications warning ====== | + | ====== Bypass |
| If you receive a PC specs warning when starting the software, it means that your PC does not meet the minimal system requirements required to run the version of QuickShow that you are using. | If you receive a PC specs warning when starting the software, it means that your PC does not meet the minimal system requirements required to run the version of QuickShow that you are using. | ||
| - | **This also means that we cannot guarantee stable output on your laser equipment. We highly advice to use hardware that meets the [[quickshow: | + | **This also means that we cannot guarantee stable output on your laser equipment. We highly advice to use hardware that meet the [[quickshow: |
| Line 11: | Line 11: | ||
| You can disable this warning by adding a piece of text to the QS.ini file. | You can disable this warning by adding a piece of text to the QS.ini file. | ||
| - | - Open up the QS.INI text file that you will find inside the main directory of your QuickShow installation. (Most often, | + | - Locate |
| - Right click on QS.ini and open up the file with notepad. | - Right click on QS.ini and open up the file with notepad. | ||
| - Copy the text from the block below and paste this at the bottom of the QS.INI file. | - Copy the text from the block below and paste this at the bottom of the QS.INI file. | ||
quickshow/bypass_specs_warning.1583188616.txt · Last modified: 2020/06/11 19:22 (external edit)
