Complete Help Docs

Laser Show Technology for Lighting Professionals

User Tools

Site Tools


quickshow:enable_laser_output

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
quickshow:enable_laser_output [2019/07/30 12:23]
Bob Varkevisser [Laser output is always disabled by default]
quickshow:enable_laser_output [2020/06/11 19:20] (current)
Line 1: Line 1:
 +====== Enable Laser Output button ======
 +
 +The Enable Laser Output button is found at the far right of the toolbar, just above the Laser Preview window.
 +
 +{{:quickshow:tb_enablelaser.jpg|}}
 +
 +===== Enabling laser output =====
 +
 +In order to enable output from the FB3 laser controller, the Enable Laser Output button must be pressed.
 +
 +===== Laser output is always disabled by default =====
 +
 +Since there is a possibility that an untrained operator might activate the laser during a time that is not appropriate (for example, when workers are in a room preparing for an event), laser output is always disabled by default, and it is always required for the laser operator to consciously activate laser output.
 +
 +**All editors and setup windows also have their own Enable Laser Output (Show it now) button**
 +
 +The **Enable Laser Output** button on the QuickShow toolbar is not the only Enable Laser Output button. In fact, each editor window, and setup window within QuickShow also has a button named **Show it now** which will enable the output from that specific window. Again, the laser operator must consciously enable laser output in order to get any output from QuickShow.
 +
 +
 +----
 +
 +See Also
 +
 +  * [[quickshow:blackout_and_pause|Blackout and Pause buttons]]
 +  * [[quickshow:main_control_window|Main Control Window]]
 +
 +[[quickshow:|Return to Index]]