This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
safety:pass [2021/04/01 17:53] Bob Varkevisser [Control Panel Signals] |
safety:pass [2021/04/27 20:07] Bob Varkevisser [PASS Power and X-Y position signal connections] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | --WORK IN PROGRESS-- | ||
- | |||
====== PASS ====== | ====== PASS ====== | ||
Professional Audience Safety System | Professional Audience Safety System | ||
Line 68: | Line 66: | ||
===== Control Panel Signals ===== | ===== Control Panel Signals ===== | ||
- | {{ : | + | {{ : |
A control panel may optionally be used with PASS. The control panel may have a ESTOP switch (i.e. mushroom emergency stop switch), as well as a manual reset button, which may be embodied as a keyswitch or push button. When a control panel is used with PASS, a Manual Reset is required in order to activate PASS, and thus, start projector operation. In most cases, this is a simple keyswitch action but could also be a simple momentary push button. And when a Control Panel is used, PASS continually monitors the ESTOP button. If the ESTOP is pressed, PASS will immediately terminate all color and intensity signals, and forcibly close the shutter. PASS will also open the projector interlock signal path (ILDA pins 4 and 17). | A control panel may optionally be used with PASS. The control panel may have a ESTOP switch (i.e. mushroom emergency stop switch), as well as a manual reset button, which may be embodied as a keyswitch or push button. When a control panel is used with PASS, a Manual Reset is required in order to activate PASS, and thus, start projector operation. In most cases, this is a simple keyswitch action but could also be a simple momentary push button. And when a Control Panel is used, PASS continually monitors the ESTOP button. If the ESTOP is pressed, PASS will immediately terminate all color and intensity signals, and forcibly close the shutter. PASS will also open the projector interlock signal path (ILDA pins 4 and 17). | ||
Line 163: | Line 161: | ||
{{ : | {{ : | ||
- | PASS monitors the power supplies that feed the scanner amplifiers. This voltage can be between +/-20 volts and +/- 30 volts. The manor in which you connect PASS to the power supply and to the scanner amplifiers depends heavily upon whether you are using two separate single-axis scanner amplifiers, or one dual-axis scanner amplifier. | + | PASS monitors the power supplies that feed the scanner amplifiers. This voltage can be between +/-20 volts and +/- 30 volts. The manner |
If you are using two separate single-axis scanner amplifiers, the recommended connections are shown below: | If you are using two separate single-axis scanner amplifiers, the recommended connections are shown below: |