User Tools
safety:pass
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
safety:pass [2021/04/01 17:54] Bob Varkevisser [Control Panel Signals] |
safety:pass [2021/04/27 20:07] Bob Varkevisser [PASS Power and X-Y position signal connections] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | --WORK IN PROGRESS-- | ||
| - | |||
| ====== PASS ====== | ====== PASS ====== | ||
| Professional Audience Safety System | Professional Audience Safety System | ||
| Line 163: | Line 161: | ||
| {{ : | {{ : | ||
| - | PASS monitors the power supplies that feed the scanner amplifiers. This voltage can be between +/-20 volts and +/- 30 volts. The manor in which you connect PASS to the power supply and to the scanner amplifiers depends heavily upon whether you are using two separate single-axis scanner amplifiers, or one dual-axis scanner amplifier. | + | PASS monitors the power supplies that feed the scanner amplifiers. This voltage can be between +/-20 volts and +/- 30 volts. The manner |
| If you are using two separate single-axis scanner amplifiers, the recommended connections are shown below: | If you are using two separate single-axis scanner amplifiers, the recommended connections are shown below: | ||
safety/pass.txt · Last modified: 2021/04/27 20:10 by Bob Varkevisser
