This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
safety:pass [2021/04/27 20:09] Bob Varkevisser [License Agreement and Limited Warranty] |
safety:pass [2021/04/27 20:10] (current) Bob Varkevisser [PASS Power and X-Y position signal connections] |
||
---|---|---|---|
Line 161: | Line 161: | ||
{{ : | {{ : | ||
- | PASS monitors the power supplies that feed the scanner amplifiers. This voltage can be between +/-20 volts and +/- 30 volts. The manner | + | PASS monitors the power supplies that feed the scanner amplifiers. This voltage can be between +/-20 volts and +/- 30 volts. The manor in which you connect PASS to the power supply and to the scanner amplifiers depends heavily upon whether you are using two separate single-axis scanner amplifiers, or one dual-axis scanner amplifier. |
If you are using two separate single-axis scanner amplifiers, the recommended connections are shown below: | If you are using two separate single-axis scanner amplifiers, the recommended connections are shown below: |