This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
quickshow:midi_settings [2019/06/12 17:40] Bob Varkevisser [Enabled Channels] |
quickshow:midi_settings [2019/10/08 19:50] Igor Strakhov [Enabled Channels] |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== MIDI Settings ====== | ||
+ | |||
+ | QuickShow includes extensive support for MIDI keyboards and controllers. All aspects of MIDI are setup with the MIDI Settings dialog box. | ||
+ | |||
+ | ===== MIDI Devices ===== | ||
+ | |||
+ | This tab allows you to select up to four MIDI Input devices and one MIDI Output device. Once you have selected the Input Devices, you should configure each device on the Input Options tab. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | ===== Input Options ===== | ||
+ | |||
+ | This tab allows you to configure the operation of each input device. Tabs on the bottom of this panel allow you to select MIDI In #1 through MIDI In #4. The name of each device is displayed at the top. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ==== Channel and Page ==== | ||
+ | |||
+ | QuickShow supports up to four MIDI Input devices, such as keyboards or " | ||
+ | |||
+ | ==== First Key ==== | ||
+ | |||
+ | The "First key" sets the key that will be used to trigger the top-left cue in the cue grid. Higher notes on the MIDI keyboard will trigger incrementally higher QuickShow cues. | ||
+ | |||
+ | ==== Echo ==== | ||
+ | |||
+ | This controls whether or not QuickShow will send MIDI messages received by this device back out to the MIDI Output device. Normally Echo is not enabled, but it may be handy in situations where QuickShow is incorporated into the MIDI stream of an intricate MIDI music studio. All normal messages will be echoed but System Exclusive (SYSEX) messages will not be echoed. | ||
+ | |||
+ | **Important Note:** If the Channel is not set to "Use original Channel" | ||
+ | |||
+ | |||
+ | ===== Enabled Channels ===== | ||
+ | |||
+ | |||
+ | This tab allows you to either ignore or process messages, depending on the Channel number that is encoded in each MIDI message. Normally all channels should be left Enabled, but you may disable one or more channels if QuickShow is used in a MIDI environment that involves a number of MIDI instruments. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | See Also | ||
+ | |||
+ | * [[quickshow: | ||
+ | |||
+ | [[quickshow: |