This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
hardware:fb4:manual [2023/08/07 11:50] Bob Varkevisser [Power Input] |
hardware:fb4:manual [2023/08/07 11:53] Bob Varkevisser [Power Input] |
||
---|---|---|---|
Line 384: | Line 384: | ||
The power requirement is a single +5 to +30 volts DC, at 2 watt. This may be sourced from the same power supply that feeds the scanners or laser diode drivers. | The power requirement is a single +5 to +30 volts DC, at 2 watt. This may be sourced from the same power supply that feeds the scanners or laser diode drivers. | ||
- | **Note: On new FB4, the power connector has been replaced by an 2-pin JST PH cable.** | + | **Note: On new FB4, the power connector has been replaced by an 2-pin JST PH cable connector.** |
{{: | {{: |