hardware:fb4:manual
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| hardware:fb4:manual [2023/08/07 11:50] – [Power Input] Bob Varkevisser | hardware:fb4:manual [2023/08/07 11:53] (current) – [Power Input] Bob Varkevisser | ||
|---|---|---|---|
| Line 384: | Line 384: | ||
| The power requirement is a single +5 to +30 volts DC, at 2 watt. This may be sourced from the same power supply that feeds the scanners or laser diode drivers. | The power requirement is a single +5 to +30 volts DC, at 2 watt. This may be sourced from the same power supply that feeds the scanners or laser diode drivers. | ||
| - | **Note: On new FB4, the power connector has been replaced by an 2-pin JST PH cable.** | + | **Note: On new FB4, the power connector has been replaced by an 2-pin JST PH cable connector.** |
| {{: | {{: | ||
hardware/fb4/manual.1691401859.txt · Last modified: by Bob Varkevisser