Fulltext results:
- Networking for Lasershows, QuickShow, and Entertainment
- below for IP, Mask and gateway. This can also be done in FB4 Settings window. {{:quickshow:networkingf... as you can imagine, that is much easier said than done. There are a couple caveats. You will often fin... use of "Purple FB4" ==== Now most users who have done laser shows will have seen the “purple fb4” notif... ompletely ruin your install/ break your driver if done incorrectly so I will not be providing documentat
- QuickShow 5.0 Registration System FAQ
- recover lost or stolen hardware. This process is done over the internet or done over email. If your show computer is connected to the internet, this is done automatically, and you will not even notice it ha... nd computer, so registration will only need to be done once for any specific setup, or hardware-pc combi
- Projector Settings
- a single piece of hardware to a file. This can be done to backup your settings, or move to another PC or... t relate to your software license or key. That is done under the "Registration" tab of QuickShow. You li... t this at 100x100 and leave everything else to be done in "Projection Zones" instead. However there are
- Projection Zones
- for audience scanning viewers. This can easily be done by selecting a reduced brightness level, and fill
- Cue Grid
- F-key assignments and naming of the pages can be done using the Page menu, or by right-clicking on a Pa
- QuickText
- he **T Edit**... or **A Font**... buttons must be done last. If you click on a different effect, it will