Fulltext results:
- Hardware connection diagrams
- 4 - Extended console setup ==== We have two laser projectors connected to a DMX console or computer via the in... hardware interface through DMX or Art-net. These projectors have an onboard switch which allows you to daisy
- FB4 SE Manual @hardware:fb4
- ay]** allows for scheduling shows across multiple projectors. When setting up a show which uses multi FB4’s, o... control of DMX controllable hardware inside Laser Projectors. This DMX function does not require the FB4 DMX d
- FB4 Scan-Fail (Scan Guard) For Audience Scanning @hardware:fb4
- ence scanning effects are created using dedicated projectors for the effect, while the overhead effects are created using separate higher power projectors. It is however possible to use a single projector
- Firmware updates
- installed in the FB4. If you need to update your projectors without a connection to the software, then you ca... one and then use this SD card for update of other projectors. In a rare situation, you can also upload a fir
- FB4 Content Pack @hardware:fb4
- ra Simples" just takes 30 seconds to upload to 10 projectors, while "FB4 Beam Content Pack 1.0" the full pack, could take up to an hour for 10 projectors. In pangolin created content packs, the cue index
- Status bar color scheme of FB4 @hardware:fb4
- goes up as with more effects, more tracks, more projectors. Software start processing 25 ms ahead of time. T
- FB4 BEAM CONTENT PACK PACKET @hardware:fb4
- content pack. It takes only moments to upload to projectors and gives 80 gobos. Use this if you are on site a