Fulltext results:
- FB4 SE Manual @hardware:fb4
- [BEYOND/QS]**, Change **[Artnet Settings]** >> **[Timeout]** to 3.0). ===== Features ===== * 100Mb... power cycle. When starting up the FB4 the first time, the default **[Operation Mode]** is **[BEYOND/QS... to start and play content at specific predefined times or when the power of the laser is turned on. Aut... d content needs to be played on specific date and times, installation of a battery is needed. As deliver
- Status bar color scheme of FB4 @hardware:fb4
- CPU overload. Software cannot calculate in output time, and it leads to delayed delivery. 2nd is network congestion. Data cannot be delivered in time from PC to FB4.| ===== Icon Legend ===== ^ Icon... s. ==== Software speed ==== Laser output is real time process. However, calculation and communication takes some times. Longer time inject lag but help to avoid flick
- FB4 and OSC @hardware:fb4
- nguard_minimum_velocity|0|300| | |scanguard_dwell_time|1|300| | |scanguard_attenuation|SOFT|HARD|SO... |artnet_channel|1|512| | |dmx_artnet_timeout|0|50| | |network_autoip|NO|YES|NO = 14... utes|0|59| | |rtc_seconds|0|59| | |timecode_offset_h|0|12| | |timecode_offset_m|0|59| | |timecode_offset_s|0|59| | |t
- Hardware connection diagrams
- each laser can do something different at the same time, because they each have their own hardware connec... h, both lasers will do the same thing at the same time. {{ :hardware:fb4e_shared_control_setup.png?direc... each laser can do something different at the same time, because they each have their own hardware connec... each laser can do something different at the same time, because they each have their own hardware connec
- FB4 QuickStart Guide @hardware:fb4
- tting started ===== When using FB4 for the first time. Take the following steps: - Make sure the inc... of cues immediately after power-up or at specific times. In this mode, geometric correction can be applied natively on FB4. **Time Code** In time code mode, FB4 plays content from the SD card in sync with an external timecode source.
- FB4 Scan-Fail (Scan Guard) For Audience Scanning @hardware:fb4
- ases as larger numbers are specified. ==== Dwell Time (0 – 999) ==== This parameter allows the user to specify the time in ms that the laser effect may output at the min... city before shutting the output off. ==== Rescan Time (0 - 999) ==== This parameter is not actually re... tics, but instead refers to the maximum amount of time the FB4 should rescan the network connection, in
- FB4 Content Pack @hardware:fb4
- can be up to 1GB, keep this in mind for download times when you are on a job site. Downloading of cust... rdware-browser.png?400|Hardware Browser}} Upload times can vary a lot, please keep this in mind if you ... o this on a show site. If you don’t have a lot of time and want to get going quickly, We recommend using
- Firmware updates
- firmware version in the connected hardware every time the program is started, and offers to update the ... controller has the correct firmware build, every time it is connected. ===== FB4 Firmware Update Deta
- FB4 16 Channel DMX Profile layout @hardware:fb4
- el fixture profiles are not available at the same time. ^Channels^Value^Function^Description^Width^ |1
- FB4 BEAM CONTENT PACK PACKET @hardware:fb4
- Use this if you are on site and do not have much time available. Each page has these shapes: {{:hardwa