Fulltext results:
- FB4 BEAM CONTENT PACK PACKET @hardware:fb4
- Every cue in this content pack was made to be 500 points, Exceptions were made in more complex cues, or cues that played back better at lower point counts. This should provide 60FPS on over 98% of ... n order to provide the least number of tails, hot points, and smoothly completing circles.** **Each cue ... It easy to have on hand, dpending on the printer, point cues will be hard to decern. ===== Ultra Simples
- FB4 39 Channel DMX Profile layout @hardware:fb4
- 55 = 0 till 100% alpha blending)|8 Bit| |37|0-255|Points start|Allows you to remove points from the start point of a cue\\ (Range from 100 till 0% visibility)|8 Bit| |38|0-255|Points End|Allows you to remove points from the end poi
- FB4 16 Channel DMX Profile layout @hardware:fb4
- = center\\ 255 = bottom|8 Bit| |12|0-255|Visible points|Zero Points till 100% of points visible|8 Bit| |13 ((Lowering the scan rate can impact the cue speed of the laser))
- FB4 SE Manual @hardware:fb4
- pose is “CR1220”. The battery can be installed by pointing the negative side of the battery towards the c... shift**] Allows adjustment of the overlay of end points of colors for optimal line results. * [**Red**
- Status bar color scheme of FB4 @hardware:fb4
- ync of refresh rate. It means – you send too many points for currently selected FPS and Sample rate. It i... mpossible to display such output. As example 1000 points at 100 FPS at 30K output. Such notification come
- FB4 QuickStart Guide @hardware:fb4
- vating the display, turn the knob until the arrow points at the menu item “Operation Mode”. {{:fb4:fb4-... b4-menu3.png|}} Turn the knob until the arrow is pointing at the desired operating mode (ILDA Input) {{
- FB4 Scan-Fail (Scan Guard) For Audience Scanning @hardware:fb4
- 50%, which means that area below the vertical midpoint of the maximum scanning extent is protected by th