This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
tools:lc4d:object_tag_object_point_spacing [2021/05/02 10:43] Bob Varkevisser [AutoAnchor Points] |
tools:lc4d:object_tag_object_point_spacing [2021/05/02 10:45] (current) Bob Varkevisser [See Also] |
||
---|---|---|---|
Line 53: | Line 53: | ||
**Curve detection** controls the sensitivity to curves. The minimum setting of 0 means no curves are detected -- the visible density for straight lines is always used. The maximum setting of 100, means Lasershow Converter 4D will place a high density on lines even if they are only slightly curved. | **Curve detection** controls the sensitivity to curves. The minimum setting of 0 means no curves are detected -- the visible density for straight lines is always used. The maximum setting of 100, means Lasershow Converter 4D will place a high density on lines even if they are only slightly curved. | ||
- | Note that with all of this flexibility, | + | Note that with all of this flexibility, |
**Beam Path for this object** controls the path that the laser beam follows, when drawing the selected object. | **Beam Path for this object** controls the path that the laser beam follows, when drawing the selected object. | ||
Line 68: | Line 68: | ||
===== See Also ===== | ===== See Also ===== | ||
- | Tips: Beam path optimization | + | * [[tools: |
- | Tips: Color and path consistency | + | * [[tools: |
- | Tips: Point spacing for lines \\ | + | * [[tools: |
- | Tips: Point spacing for objects | + | * [[tools: |
---- | ---- | ||
[[tools: | [[tools: |