This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
tools:lc4d:tip_scan_speeds_and_lc4d [2021/05/02 11:16] Bob Varkevisser [Scanner tuning vs. scan speed] |
tools:lc4d:tip_scan_speeds_and_lc4d [2021/05/03 00:00] (current) Bob Varkevisser [Better scanners give better results] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Tips: Scan speeds and LC4D ====== | ====== Tips: Scan speeds and LC4D ====== | ||
- | Lasershow Converter 4D's default settings assume that: | + | Lasershow Converter 4D's default((There is no special " |
+ | \\ | ||
+ | If you make changes in the **Object Tag** and you find the results unsatisfactory, | ||
+ | \\ | ||
+ | In addition, the **Render Settings** can simply be reset by selecting the Lasershow Converter 4D in the **Post Effects** dialog of the Render Settings menu and choose **Remove Selected**. Reselecting Lasershow Converter 4D enables a new post render effect with default values.)) | ||
- your scanners are tuned to the ILDA 30K standard, and | - your scanners are tuned to the ILDA 30K standard, and | ||
Line 27: | Line 31: | ||
===== Better scanners give better results ===== | ===== Better scanners give better results ===== | ||
- | Lasershow Converter MAX gives the best results if your scanners are tuned perfectly, and the bearings are in good shape. Please make sure that the low frequency damping and high frequency damping are adjusted properly for "critical damping." | + | Lasershow Converter MAX gives the best results if your scanners are tuned perfectly, and the bearings are in good shape. Please make sure that the low frequency damping and high frequency damping are adjusted properly for “critical damping.” Pangolin recommends ScannerMAX Saturn-series scanners for best results.s. |