This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
tools:lc4d:tip_using_the_selection_tool [2021/05/02 10:38] Bob Varkevisser created |
tools:lc4d:tip_using_the_selection_tool [2021/05/02 11:24] (current) Bob Varkevisser |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Tips: Using the Selection Tool ====== | ||
+ | |||
+ | The option " | ||
+ | |||
+ | In contrast to the [[tools: | ||
+ | |||
+ | The picture below shows an example of a cone with a face selected top. The goal is to get totally different line type settings with the Lasershow Converter 4D for the cone top than for the rest of the cone. In this case, for the bottom, no specific line settings are done, so the Lasershow Converter will take the line sittings from the render plug-in. The settings for the top are taken from the LC4D object tag settings. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | To select specific faces, you have to do the following: | ||
+ | |||
+ | - Create a sphere (or any other object) in Cinema 4D. | ||
+ | - Make the object editable. \\ {{: | ||
+ | - Press the Select Faces button on the left panel. \\ {{: | ||
+ | - Select the specified faces by holding the shift key while clicking. \\ In the command bar click on **Selection -> Set Selection**. Now you can use the selection as an own object and give an identifying name. \\ {{: | ||
+ | - Create a new LC4D Object Tag. | ||
+ | - In the line Types section, check the Selection box. The text field below specifies the name of the selection. Should you want to use an Edge Selection, you'll also have to check Edge Selection (This option is different to the Edge Selection checkbox below.) \\ Now certain unnecessary options are disabled | ||
+ | - Now make the desired settings for the selection. These settings are only valid for the selection and not for the entire object. | ||
+ | - Finally, the rendered cone should look like this: \\ {{: | ||
+ | |||
+ | |||
+ | To demonstrate the differences of the settings, you may have a look to the following screen shots: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | As you can see in the Lasershow Converter 4D object tag settings, the transparency, | ||
+ | |||
+ | This example shows that the renderer takes the settings from the object tag for the selection and the render settings for the rest of the object. | ||
+ | |||
+ | ===== See Also ===== | ||
+ | |||
+ | * [[tools: | ||
+ | |||
---- | ---- | ||
[[tools: | [[tools: | ||