This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
tools:lc4d:tip_using_the_selection_tool [2021/05/02 11:22] Bob Varkevisser |
tools:lc4d:tip_using_the_selection_tool [2021/05/02 11:24] (current) Bob Varkevisser |
||
---|---|---|---|
Line 14: | Line 14: | ||
- Make the object editable. \\ {{: | - Make the object editable. \\ {{: | ||
- Press the Select Faces button on the left panel. \\ {{: | - Press the Select Faces button on the left panel. \\ {{: | ||
- | | + | |
- Create a new LC4D Object Tag. | - Create a new LC4D Object Tag. | ||
- In the line Types section, check the Selection box. The text field below specifies the name of the selection. Should you want to use an Edge Selection, you'll also have to check Edge Selection (This option is different to the Edge Selection checkbox below.) \\ Now certain unnecessary options are disabled | - In the line Types section, check the Selection box. The text field below specifies the name of the selection. Should you want to use an Edge Selection, you'll also have to check Edge Selection (This option is different to the Edge Selection checkbox below.) \\ Now certain unnecessary options are disabled | ||
- Now make the desired settings for the selection. These settings are only valid for the selection and not for the entire object. | - Now make the desired settings for the selection. These settings are only valid for the selection and not for the entire object. | ||
- | - Finally, the rendered cone should look like this: | + | - Finally, the rendered cone should look like this: \\ {{: |
- | + | ||
- | {{: | + | |
To demonstrate the differences of the settings, you may have a look to the following screen shots: | To demonstrate the differences of the settings, you may have a look to the following screen shots: | ||
- | {{: | + | {{: |