Differences

This shows you the differences between two versions of the page.

--- quickshow:enable_laser_output [2019/07/29 19:38] – [Laser output is always disabled by default] Bob Varkevisser
+++ quickshow:enable_laser_output [2020/06/11 19:20] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
+====== Enable Laser Output button ======
+The Enable Laser Output button is found at the far right of the toolbar, just above the Laser Preview window.
+{{:quickshow:tb_enablelaser.jpg|}}
+===== Enabling laser output =====
+In order to enable output from the FB3 laser controller, the Enable Laser Output button must be pressed.
+===== Laser output is always disabled by default =====
+Since there is a possibility that an untrained operator might activate the laser during a time that is not appropriate (for example, when workers are in a room preparing for an event), laser output is always disabled by default, and it is always required for the laser operator to consciously activate laser output.
+**All editors and setup windows also have their own Enable Laser Output (Show it now) button**
+The **Enable Laser Output** button on the QuickShow toolbar is not the only Enable Laser Output button. In fact, each editor window, and setup window within QuickShow also has a button named **Show it now** which will enable the output from that specific window. Again, the laser operator must consciously enable laser output in order to get any output from QuickShow.
+----
+See Also
+  * [[quickshow:blackout_and_pause|Blackout and Pause buttons]]
+  * [[quickshow:main_control_window|Main Control Window]]
+[[quickshow:|Return to Index]]