This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
quickshow:enable_laser_output [2019/07/30 12:23] Bob Varkevisser [Laser output is always disabled by default] |
quickshow:enable_laser_output [2020/06/11 19:20] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Enable Laser Output button ====== | ||
+ | |||
+ | The Enable Laser Output button is found at the far right of the toolbar, just above the Laser Preview window. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ===== Enabling laser output ===== | ||
+ | |||
+ | In order to enable output from the FB3 laser controller, the Enable Laser Output button must be pressed. | ||
+ | |||
+ | ===== Laser output is always disabled by default ===== | ||
+ | |||
+ | Since there is a possibility that an untrained operator might activate the laser during a time that is not appropriate (for example, when workers are in a room preparing for an event), laser output is always disabled by default, and it is always required for the laser operator to consciously activate laser output. | ||
+ | |||
+ | **All editors and setup windows also have their own Enable Laser Output (Show it now) button** | ||
+ | |||
+ | The **Enable Laser Output** button on the QuickShow toolbar is not the only Enable Laser Output button. In fact, each editor window, and setup window within QuickShow also has a button named **Show it now** which will enable the output from that specific window. Again, the laser operator must consciously enable laser output in order to get any output from QuickShow. | ||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | See Also | ||
+ | |||
+ | * [[quickshow: | ||
+ | * [[quickshow: | ||
+ | |||
+ | [[quickshow: | ||