This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
beyond:package-sender [2020/02/26 12:00] Bob Varkevisser created |
beyond:package-sender [2020/06/11 19:20] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Send TCP packages to BEYOND ====== | + | ====== Send packages to BEYOND ====== |
- | BEYOND accepts | + | BEYOND accepts incoming |
The advantage of this is that that this allows you to control BEYOND over ethernet. | The advantage of this is that that this allows you to control BEYOND over ethernet. | ||
- | This configuration uses the free utility package sender, but this could even be your own coded program. | + | The example |
- | ===== Enabling | + | ===== Enabling Talk server and client |
- | Enable through settings | + | Open **Settings |
- | {{: | + | {{: |
+ | |||
+ | Now you need to enable the Talk server service and talk server client service in the network settings window. Open up **Settings >> network >> Network settings**. | ||
The default ports used are 16062 for UDP and 16063 for TCP. | The default ports used are 16062 for UDP and 16063 for TCP. | ||
+ | You can also change the ports used for these two services. | ||
- | If you like to change these ports, open up Settings >> network >> | + | {{: |
+ | |||
+ | ===== Package sender example ===== | ||
+ | |||
+ | Download and install the free application [[https:// | ||
+ | |||
+ | After opening package sender, configure it like shown as the screenshot below. | ||
+ | |||
+ | Note that the address needs to be replaced to the IP address of the computer that is running BEYOND. | ||
+ | If BEYOND is running on the same machine, the IP address will be 127.0.0.1 . | ||
+ | |||
+ | In this case I am sending the command | ||
+ | |||
+ | **//Note that every command needs to be followed by \r\n (CR LF aka line separator) as shown below.// | ||
+ | |||
+ | |||
+ | {{: | ||
- | In this same window you need to enable the Talk server service and talk server client service. | ||
- | {{: | ||