This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
quickshow:bypass_specs_warning [2020/03/02 23:38] Bob Varkevisser [Bypass the specifications warning] |
quickshow:bypass_specs_warning [2020/06/11 19:20] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Bypass PC specifications warning ====== | + | ====== Bypass |
If you receive a PC specs warning when starting the software, it means that your PC does not meet the minimal system requirements required to run the version of QuickShow that you are using. | If you receive a PC specs warning when starting the software, it means that your PC does not meet the minimal system requirements required to run the version of QuickShow that you are using. | ||
- | **This also means that we cannot guarantee stable output on your laser equipment. We highly advice to use hardware that meets the [[quickshow: | + | **This also means that we cannot guarantee stable output on your laser equipment. We highly advice to use hardware that meet the [[quickshow: |
Line 12: | Line 12: | ||
- Locate the QS.INI text file that you will find inside the main directory of your QuickShow installation. (Most often, this file is located in the directory C: | - Locate the QS.INI text file that you will find inside the main directory of your QuickShow installation. (Most often, this file is located in the directory C: | ||
- | - Right click on QS.ini and open up the file with "notepad". | + | - Right click on QS.ini and open up the file with notepad. |
- Copy the text from the block below and paste this at the bottom of the QS.INI file. | - Copy the text from the block below and paste this at the bottom of the QS.INI file. | ||