If you receive a PC specs warning when starting the software, it means that your PC does not meet the minimal system requirements required to run the version of BEYOND that you are using.

This also means that we cannot guarantee stable output on your laser equipment. We highly advice to use hardware that meet the minimum system requirements.

You can disable this warning by adding a piece of text to the QS.ini file.

1. Locate the BEYOND.INI text file that you will find inside the main directory of your BEYOND installation. (Most often, this file is located in the directory C:\BEYOND\ ).
2. Right click on BEYOND.ini and open up the file with notepad.
3. Copy the text from the block below and paste this at the bottom of the BEYOND.INI file.

Once the text is added, BEYOND will not check your PC specifications and will open.

[PC]
AlwaysCheckPC=0